We have installed dialer with 90 ports. In the dialer window it shows as [CM-A][CTI-A][Ports: C90,R0,B0][MR-A]. The dialer ports are showing as configured but not getting configured. MR PIM is also in active state.
the Dialer ports are getting registered in CCM. I added these dialer ports in Call Manager as Standard 30 VIP phones. I added these phones to PGUser as well. CCM PG is operational.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.