Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Outbound Calling Only

I am running Call Manager System version: 6.1.3.3190-1. I have a few lines that are used for AV purposes that keep getting interrupted by calls. Is there an easy way to block ALL inbound calls to these selected lines? I considered a separate partition, but I want to make sure no calls are prevented from being dialed out.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Outbound Calling Only

The only way CUCM has to segment access is CSS and partitions. You can easily configure that inbound calls do not reach the phones by changing the inbound CSS of the GWs.

If you want the phones to dial out just make sure their CSS has the route patterns to PSTN.

It's extremely easy to configure scenarios where you can reach someone but the other guy cannot reach you, it's all CSS and partitions.

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
2 REPLIES
Cisco Employee

Re: Outbound Calling Only

The only way CUCM has to segment access is CSS and partitions. You can easily configure that inbound calls do not reach the phones by changing the inbound CSS of the GWs.

If you want the phones to dial out just make sure their CSS has the route patterns to PSTN.

It's extremely easy to configure scenarios where you can reach someone but the other guy cannot reach you, it's all CSS and partitions.

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
New Member

Re: Outbound Calling Only

I had a feeling that was what was needed, I was just unsure about which CSS's to include and which to exclude, thank you for your help!

117
Views
0
Helpful
2
Replies
CreatePlease login to create content