We have using Cisco UC520 Router with two analog line, I did just trying to make an outbound call and I have found that it is dropping the call after approx 10 seconds, Have the same issue with calls disconnecting, in that the line goes dead ranges from 2 – 10 mins However the LED on the UC520 showing which line is busy, stays on and gives a busy signal if trying to use the line again, I had a call last about 10 mins yesterday,yet tried one this afternoon it disconnected after ringing three times before the call was even connected generally seems to get through 2-3 mins.
can anyone suggest me, What could be the problem there,
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...