Re: PerfDisk errors in eventlog - Unity 4.2 on HP platform
Hi Scott -
You should be able to go to a command prompt on the Unity server and run diskperf -y to reenable the disk performance counters. This will require a reboot though. If you run just diskperf, it will show the other available switches, including the current status. When you press Enter, the following code appears:
Disk performance counters on this system are currently set to start at boot.
DISKPERF [-Y[E] : -N] [\\computername]
Sets the system to start disk performance counters when the system is restarted.
Enables the disk performance counters used for measuring performance
of the physical drives in striped disk set when the system is
Specify -Y without the E to restore the normal disk performance
Sets the system disable disk performance counters when the system is
Is the name of the computer you want to see or set disk performance
counter use. I've never used the platform CD/DVD, always installed the OS myself, so I don't know if there is a problem there. I didn't find anything on Cisco related to having these counters disabled as far as Unity goes.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...