Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Permission Denied - CUCM 9.0(1) installation

I am have serious issues trying to get Cisco Unified Call Manager v 9.0 (1) installed into a test lab and am looking for assistance. Ha! I can't seem to get past the initial logon area successfully.

I am using VMPlayer v10 (latest available as of this time), configured with 4gb memory, 180gb scsi hard drive, 1 processor, network bridged adapter, OS set as Red Hat Linux enterprise v5. I have also tried Red had v4 and then v6 as well.

I continue to get prompted several times for a logon after the installation. After I enter my logon information I get in successfully (so I know my credentials are correct). But, I also get "Permission Denied" errors at "/usr/local/platform/bin/c

liscript.sh:" at various lines such as 135, 145, 17, and 18.

I also get an IOException: hardware API:Cannot run program "/usr/local/bin/base_scrip

ts/ihardware_iml": java.io.ioexception: error=13, Permission denied"

I have attached a screenshot for reference.

I've searched high and low for some answers and am usually pretty successful with research, but am truly stuck this time. Any assistance on this is appreciated. I am very new to CUCM and am trying to get it going in a lab.

Thank you.

Everyone's tags (3)
1 REPLY

Hi,Can you try using VMware

Hi,

Can you try using VMware esxi 5.x and one of the supported OVA files for 9.0 from the following link

 

http://software.cisco.com/download/release.html?mdfid=284329957&flowid=45899&softwareid=283088407&release=9.0%281%29&relind=AVAILABLE&rellifecycle=&reltype=latest

 

HTH

Manish

 

217
Views
0
Helpful
1
Replies
CreatePlease to create content