Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Phone shows bullseye and Hangs after Factory Reset

Hello All,

             So i had an issue with the "Authentication load failure" on my 7941.  I loaded an 8.5.2 code into both call managers but the 7941 was still trying to download the old code I had in there, which was 8.5.3.  Now I did a factory reset but the phone comes up as upgrading and it download the term file then it shows a bullseye and reloads itself, it does this constantly?  How can I fix this and how can I get current phones to download the new code in  call manage rather then the old one that was in there?  Is the problem that the term41.default file is not on the call manager?  thanks

Jason

1 ACCEPTED SOLUTION

Accepted Solutions
Red

Re: Phone shows bullseye and Hangs after Factory Reset

Did you specify the firmware version from CUCM?  If not, plase go to CUCM Admin > Device > Device Settings > Device Defaults to specify the firmware version (8.5.2).

Hope this helps!

Michael

http://htluo.blogspot.com

1 REPLY
Red

Re: Phone shows bullseye and Hangs after Factory Reset

Did you specify the firmware version from CUCM?  If not, plase go to CUCM Admin > Device > Device Settings > Device Defaults to specify the firmware version (8.5.2).

Hope this helps!

Michael

http://htluo.blogspot.com

1468
Views
0
Helpful
1
Replies
CreatePlease to create content