Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Silver

Phoneview and connection

Has anyone got this working. It seems you add an Application user and assign it to the device and in Connection create this CTI user in the phone system set up as well as adding the feature to the user, - nothing else. However when you use the messages button on CCM you only get the voice prompt press 1 to listen etc , the screen of the phone 7941 does not change from the normal off hook display. I played around with the authenticate URL on both connection and ccm pointing it to Connection http://x.x.x.x:8080/ccmcip/authenticate.jsp as someone mentioned this as well. Do you not need to assign the CTI user to any ports in CCM?

many thanks

3 REPLIES
Silver

Re: Phoneview and connection

I have phone view working with Unity and it was not difficult. Here are the steps I found for connection and should be about tne same.

This is for connection

http://www.cisco.com/en/US/docs/voice_ip_comm/connection/2x/user_mac/guide/2xcucmac040.html#wp1108919

this is the guide I followed for Unity.

http://www.cisco.com/en/US/docs/voice_ip_comm/unity/5x/administration/guide/ex/5xcusag115e.html

New Member

Re: Phoneview and connection

I've pretty much followed the guide for UC7/CUCM6 and am still having problems with PhoneView. Did you ever get this working?

New Member

Re: Phoneview and connection

I found a post on netpro where someone says It's supported only by UC7/CUCM 7

199
Views
0
Helpful
3
Replies
CreatePlease to create content