Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

PIMG Question- Nortel

Can the PING integrate w/ A Nortel M-1 PBX w/ the PBX running an older RLS of software…RLS 25.40

Thanks in Advance

  • Unified Communications Applications
1 REPLY
Hall of Fame Super Red

Re: PIMG Question- Nortel

Hi Jack,

Have a look at the following Nortel PBX requirements for the PIMG integration;

Cisco Unity

Nortel Meridian 1 PIMG Integration Guide for Cisco Unity 4.0

Requirements

----------------------------------

The Nortel Meridian 1 integration supports configurations of the following components:

Phone System

•One of the following models:

–Nortel Meridian 1 phone system (Option 11, 21, 51, 61, 71, or 81), software release 17 or later.

–Nortel Succession phone system, software release 3.0 or later.

–The Nortel SL 1 phone system, when upgraded to Meridian 1 so that it is compatible with the M2616 digital phone.

•The following software option packages installed:

–Package 19, Digit Display Software (DDSP)

–Package 46, Message Waiting Center (MWC)

•One or more digital lines that are compatible with the M2616 digital phone for connecting to the PIMG units.

•One or more of the applicable PIMG units. For details, refer to the "Supported Circuit-Switched Phone System Integrations" section in your version of Cisco Unity System Requirements at http://www.cisco.com/en/US/products/sw/voicesw/ps2237/prod_installation_guides_list.html.

•The voice messaging ports in the phone system connected by digital lines to the ports on the PIMG units.

We recommend that you connect the voice messaging ports on the phone system to the ports on the PIMG units in a planned manner to simplify troubleshooting. For example, the first phone system voice messaging port connects to the first port on the first PIMG unit, the second phone system voice messaging port connects to the second port on the first PIMG unit, and so on.

•The PIMG units connected to the same LAN or WAN that Cisco Unity is connected to.

•If the PIMG units connect to a WAN, the requirements for the WAN network connections are:

–For G.729a codec formatting, a minimum of 32.76 Kbps guaranteed bandwidth for each voice messaging port.

–For G.711 codec formatting, a minimum of 91.56 Kbps guaranteed bandwidth for each voice messaging port.

–No network devices that implement network address translation (NAT).

–A maximum 200 ms network latency.

•The phone system ready for the integration, as described in the documentation for the phone system.

From this doc;

http://www.cisco.com/en/US/products/sw/voicesw/ps2237/prod_configuration_guide09186a0080430d68.html#wp1022253

Hope this helps!

Rob

Please remember to rate helpful posts.........

"May your heart always be joyful And may your song always be sung May you stay forever young " - Dylan
130
Views
4
Helpful
1
Replies
This widget could not be displayed.