please see the ISDN debug output of a call not getting completed, any suggestions??

[khanm1977]

Jun 14 16:05:15.587: ISDN Se0/1/0:23 Q931: TX -> SETUP pd = 8  callref = 0x18AB
        Bearer Capability i = 0x8090A2
                Standard = CCITT
                Transfer Capability = Speech
                Transfer Mode = Circuit
                Transfer Rate = 64 kbit/s
        Channel ID i = 0xA98393
                Exclusive, Channel 19
        Calling Party Number i = 0x0081, '6079749000'
                Plan:Unknown, Type:Unknown
        Called Party Number i = 0x80, '15106758100'
                Plan:Unknown, Type:Unknown
Jun 14 16:05:15.671: ISDN Se0/1/0:23 Q931: RX <- CALL_PROC pd = 8  callref = 0x9
8AB
        Channel ID i = 0xA98393
                Exclusive, Channel 19
Jun 14 16:05:16.155: ISDN Se0/1/0:23 Q931: RX <- STATUS pd = 8  callref = 0x98AB

        Cause i = 0x82AB46 - Access information discarded
        Call State i = 0x03
Jun 14 16:05:16.159: ISDN Se0/1/0:23 Q931: RX <- PROGRESS pd = 8  callref = 0x98
AB
        Progress Ind i = 0x8288 - In-band info or appropriate now available
Jun 14 16:05:20.455: ISDN Se0/1/0:23 Q931: RX <- PROGRESS pd = 8  callref = 0x98
AB
        Cause i = 0x8081 - Unallocated/unassigned number
        Progress Ind i = 0x8288 - In-band info or appropriate now available
Jun 14 16:05:20.675: ISDN Se0/1/0:23 Q931: RX <- PROGRESS pd = 8  callref = 0x98
AB
        Cause i = 0x8281 - Unallocated/unassigned number
        Progress Ind i = 0x8288 - In-band info or appropriate now available
Jun 14 16:05:22.403: ISDN Se0/1/0:23 Q931: TX -> DISCONNECT pd = 8  callref = 0x
18AA
        Cause i = 0x8190 - Normal call clearing
Jun 14 16:05:22.439: ISDN Se0/1/0:23 Q931: RX <- RELEASE pd = 8  callref = 0x98A
A
Jun 14 16:05:22.455: ISDN Se0/1/0:23 Q931: TX -> RELEASE_COMP pd = 8  callref =
0x18AA
Jun 14 16:05:23.859: ISDN Se0/1/1:23 Q931: RX <- STATUS_ENQ pd = 8  callref = 0x
989F
Jun 14 16:05:23.863: ISDN Se0/1/1:23 Q931: TX -> STATUS pd = 8  callref = 0x189F

        Cause i = 0x829E - Response to STATUS ENQUIRY or number unassigned
        Call State i = 0x0A

[Aaron Harrison]

Hi

Unallocated/unassigned number - suggests your called number is not correct.

Called Party Number i = 0x80, '15106758100'
- Do you have a national access digit, like 0 that needs to go in as a prefix?

Aaron

[khanm1977]

Aaron,

This call is an Long Distance call and a specific RL and RG was assigned.

The RP created was 9.1XXXXXXXXXX and pre-dot to remove 9 and send the 11 digit number out to PSTN cloud.

I hope this helps.