1. sometimes CUPC font is being changed automatically without any manual change from the users!!!
2. The integration between CUPC and the IP phone is lost if a user logs out from the IP phone Extension Mobility and then logs in again. To let the integration work again, the client must be restarted or disable the desk phone from the client and enable it again!!!
3. Sometimes IM messages are not received saying that Person did not receive your message because the message could not be sent, as per Cisco troubleshooting guide again later or use another method to contact this person (which is not accepted by customer)
I ran into an issue that I had to setup a policy map on our FWSM to keep the SIP connection sopened for 6 hours. This solved the "message cannot be delivered" as CUP was not aware that the FWSM had closed the connection and could not send the message.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...