PRI with CME - Displaying Caller Name

[michaelkosmoski]

We are deployinga CME/CUE 2851 Router with 1 PRI Connected to it. When we get Inbound Calls on the PRI, only the calling number is being displayed, not the calling party name. Is their something on the Gateway Inbound Dial Peer that has to be set? I have a direct inward dial statement in their on the Dial Peer. Or is it something from within the GUI I have to enable?

[#2]

Try adding the command "isdn supp-service name calling" under the Serial interface.

interface Serial0/0/0:23

no ip address

encapsulation hdlc

isdn switch-type primary-ni

isdn incoming-voice voice

isdn supp-service name calling

auto qos voip

no cdp enable

[iwintersteiger]

Thanks...this did it!

[paolo bevilacqua]

Hi,

Please take "debug isdn q931" with "term mon" for an incoming call. Post output here.