01-09-2014 08:36 AM - edited 03-19-2019 07:44 AM
Hi
I have the following setup:
CUCM 9.1.2
Unity Connection 9.1.2
IM&P 9.1.1
CPC-P 10.0
So far I was able to sync CUCM with CPC-P, but still cannot sync Unity Conn and IM&P does someone has the configuration steps for these two products?
FYI, I followed this link for Provisioning:
http://docwiki.cisco.com/wiki/Setting_up_Devices_for_Prime_Collaboration_Provisioning
Kinds Regards
Carlo
Solved! Go to Solution.
01-13-2014 11:10 AM
I think the issue here is that the docwiki does not break the Standard from Advanced licensing, the advanced does support the previous versions, so this is why this is contradicting. With Standard only version 10 is supported.
HTH,
Chris
01-10-2014 06:58 AM
Is your Prime Collaboration licensed as Advanced or is it standard? As standard 10.0 only supports 10.0 UC apps.
Chris
01-13-2014 07:17 AM
Thanks Chris,
Is the Standard version.
I review the compatibility matrix and it seems contradictory, in this link, it says version 9.x is supported.
http://www.cisco.com/en/US/products/ps12363/products_device_support_tables_list.html
But in this one (as you pointed out) it says is only for 10
This is the ova I used
cpc-provisioning-10.0.0-791-small.ova
Regards
01-13-2014 10:53 AM
Right, this also points out 10.0 only support:
http://www.cisco.com/en/US/prod/collateral/netmgtsw/ps6491/ps12363/guide-07-729809.html#wp9000329
I think this is correct, but may need to check with Cisco.
HTH,
Chris
01-13-2014 11:10 AM
I think the issue here is that the docwiki does not break the Standard from Advanced licensing, the advanced does support the previous versions, so this is why this is contradicting. With Standard only version 10 is supported.
HTH,
Chris
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide