I am trying to run DBWalker version 3.0.90 on a Unity 3.1(1) server, and every time I get an error about the event log file being full. The exact error is "Run-time error '-2147023394 (800705de)': Error reporting event - The event log file is full."
If I have a Windows Explorer window open while running the DBWalker, I can see that it creates a 2kb file, however, the file disappears after clicking on the OK button on the error (this also closes the DBWalker utility). Another odd thing about the file that it creates temporarily is that the file date is completely off (it gives a 2003 date, and an incorrect time).
Well, my first guess would be that, as the error states, your event log is full ;->
dbWalker writes information into the event log when it starts/finishes and if the log is full the initalization routine will fall down and it'll bail out. Try clearing out your application event log or increasing the size (and letting it auto delete entries when it gets full - other apps are going to have trouble if they can't note things in the event log as well).
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...