Question regarding the use of Built-in Bridge SIP call setup to recording device
We have an application that uses Built-in Bridge (BiB) to setup a SIP call to our recording application. Recently the topology of our network was changed and for some reason the RTP for the call is not being sent. What appears to be happenning is that the SIP messages are sent from the UCCM and once the call is established we get an end call event.
We are not sure how to troubleshoot our network to determine the root cause. Any pointers will be appreciated.
IntroductionCUCM Routing RulesDial String implementation PolicyCUCM Routing LogicSIP URI Call Routing Analysis+++ Case Study: 1 ++++++ Case Study: 2 +++Conclusion
Over the last few months, I have had the privilege of working on SI...
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...