"Message Could not be sent" in Personal Communicator
I am seeing some of these errors from certain users who get "Message could not be sent" when trying to send an instant message to someone. While the other users can instant message that same person. All the users have the exact same settings. I looked on Cisco's website for troubleshooting and their resolution was pretty worthless. Look below
Message: "Your message to [person] could not be sent."
Problem When I try to send a message, I see a notice:
â¢"[Person] did not receive your message because the message could not be sent."
â¢"[Person] is offline and cannot receive messages."
â¢Your message to [person] could not be sent.
Solution If you see this message, we recommend that you try again later or use another method to contact this person, even if the message appears to be sent. Users whose reachability status is Offline or Away cannot receive instant messages in Cisco Unified Personal Communicator
If anyone has suggestions..let me know. We are running CM 6.0. CUPC 6.0.1
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...