I would also like know if there is a way to monitor "location" bandwidth. We have a private fiber network running GigE between three locations. We've allocated 50 Mbps for voice calls (we're talking less than 1,000 phones here using G.711 codex). We run only about 40 Mbps of traffic even on a heavy day on any one segment and our delay is less than 1 ms (its a MAN).
Today, we got hit with an apparently "bandwidth leakage" issue (Cisco's term, not mine). The clue was when we used our IP phones to make certain calls, we got the message on the phone display "Not enough bandwidth" along with a reorder tone (fast busy).
Logging into Communications Manager (version 6.1(1)), navigating to Locations (and selecting the target locations) and clicking the Resync Bandwidth fixed the issue (at 12:25 PM during a business day!!).
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...