Read-Only user for Unity

[islam.irshaid]

Hi all,

how can i make read-only user to access the unity 4.2 - the administration system

just to review.

Thanks In advance

[Brandon Buffin]

In Unity admin, go to Class of Service and create a new CoS. In the new CoS, go to System Access and give it read access to administration. Then create a new subscriber and assign this CoS.

Hope this helps.

Brandon

[islam.irshaid]

Thanks to you for your help

i tried but i am facing below error :

Server.CreateObject(AvSaLocalization.AvSaLocalization.1) failed.

This is most likely an error with a DLL, probably AvSaLocalizationSvr.dll or perhaps AvSaLocaleInfoSvr.dll.

Check that these files are present, and registered with REGSVR32.

Also be sure that the appropriate MsgStoreRes.dll file is present.

Cannot continue.

(From: Global.asa: hr=0x80070005)

[Brandon Buffin]

Have you tried registering the referenced DLLs using regsvr32?

Brandon

[Bradford Magnani]

This link should get you fixed up:

http://www.cisco.com/en/US/products/sw/voicesw/ps2237/products_tech_note09186a00801651f9.shtml#k1

Hope that helps,

Brad

[islam.irshaid]

Hi ,

some thing strange happen,,

i can access the unity admin page without any authentication after i made the above procedure (Cisco Dec.)

what have i do to solve this issue,

just i need read only user

[Bradford Magnani]

You'll need to specify a new Class of Service and configure the System Access portion of it for whatever you want your user to have access to.

http://www.cisco.com/en/US/customer/docs/voice_ip_comm/unity/5x/administration/guide/ex/5xcusag170e.html

Brad