Refresh Upgrade Failed going from CUCM 7.1.5 to 8.6.2
I've seen other similar issues with the 'Refresh Upgrade Failed' error popping up, but can't some to find my error. Has anyone seen this one?
"Error detected in pre-boot phase. Unable to revert to original version. Change in software RAID casued a hard drive reformat deleting the original version. Recovery requires a reinstall and DRS restore of the prior working software version."
Needless to say, this sucks. I've already done this install in my stage environment and took copious notes. Following the Cisco directions, I installed the cop file, sftp'd the new 8.6.2 to the pyhiscal server, installed, did DRS, powered down, built new 8.6 on UCS chassis and DRS to that. All worked as documented. I was to the point on my production PUB where I had picked a time zone, said no to DHCP and changing the MTU size and it was 'installing packages.' Than, BAM, install fails and throughs this error.
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...