Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Cisco Support Community site will be in read only mode on Dec14, 2017 from 12:01am PST to 11:30am for standard maintenance. Sorry for the inconvenience.

New Member

reg: fxs config

Dear sir,

Iam trying for small lab setup i have cisco 2800 series router in that i have 2port FXS
cord is there now my set up is

I connected router G0/0 to PBX ethernet port in that pbx i have ip gateway cord now iam
trying to configure the router in such a way that iwant to call from gateway card through
FXS and from FXS to gate way cord.

Both sides i have to send a call and receive a call .In this senario how can i configure
the router FXS ports to send/receive calls.

plz help me in this config

Thanks&Regards
srinivas
9246571397

2 REPLIES
New Member

Re: reg: fxs config

On the 2800 router, have you setup dial-peers and pointed them to the PBX?

What PBX are you connecting to your 2800 router?

Here is an expamle of a dial-peer.

dial-peer voice 1 pots
description POTS incoming dial-peer
incoming called-number .
direct-inward-dial

dial-peer voice 100 pots
destination-pattern 1000
port 0/3/0

New Member

Re: reg: fxs config

Hi Mansoor Ahmed,

Thanks for ur reply and in ur config there is no session targer weather i have to give session target also

My set up is -----

   analog phone---------------PBX(ip pbx)-----------------router(2800)---fxs(2port)------analog phone

Is there any sample config

srini

165
Views
0
Helpful
2
Replies
CreatePlease to create content