Hi, thanks for the reply. This is my first encounter with MTP so I am not really familiar with the term IOS enhanced. I had tried with transcoder and conference bridge and I am able to get it to register and work. I am trying to get my call to be kept in the gateway. MTP Category are you refering to transcoder and conference bridge? Thank you very much.
If you are trying to connection a UCM 6.x I have found it is best to put the UCM version type after the priority statement as the default is CCM 3.1, IOS only allows 4.1 but it works. I have had similar probnlems.
sccp ccm x.x.x.x identifier X priority X version 4.1
When I have set these up if it is set to 3.1 by default or not, if has always rejected the registration. Can you set up the sccp ccm group using this HW and IOS? I thought that UCM needed a name to associate with?
For my configuration of the MTP device name I simply use MTPXXXXXXXXXXXX where X represent the mac address of the interface which the router is connected to the network switch. I am not very sure if the router 1760 with ios 12.4 is able to work with CUCM 6.1. For this router there is no sccp ccm group command or is there anyway to do associate. But conference bridge and transcoder is able to work without problem.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...