I need to reinstall a CUCM version 220.127.116.1100-1 after an incident in the cluster. I had to buy new hardware and now this version is out of support Cisco. I have possibility to renew the licenses in this case? And to get a boot version for this software?
Normaly the licenses for the DLU (how much phomes uses) are for lifetime ... im.not sure on call processing nodes ( active server running the ccm servive) . If you have cisco support i guess you can get tac to give you a bottable disk of cucm ver 6... now if they claim is end of every kind of support , would find it online..
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...