My client's primary Unity Connection server need to reinstall back without have any backup. Only the subscriber Unity Connection are still running on the environment production. I'm trying to reinstall primary server myself but stucked half way since i'm confusing on the software version installed at the secondary Unity Connection server. Kindly please advice or should i open TAC case for this?
This is version on the GUI web
Cisco Unity Connection Administration Version 220.127.116.1100-76
I can't find any 18.104.22.16800-76 version on the cco website to download it.
Inside terminal console this is what i found,
admin:show version active Active Master Version: 22.214.171.12400-2 Active Version Installed Software Options: uc-locale-en_GB-126.96.36.199-25.cop admin:show version inactive
No, if you lost publisher there is no way to replicate from subscriber, in fact if you don't have a backup there is nothing you can do except for manually rebuilding the server. Sorry, this is why backups are ciritical and people only worry about them when it is too late.
You can replace the publisher server or replace the hard disks in the publisher server in a Connection cluster without replacing the subscriber server. During the time that the publisher server is not functioning, the subscriber server handles all functions for the Connection cluster to avoid loss of service to the system.
When replacing either the server or the hard disks in the server, you must install a replacement publisher server; you cannot convert the subscriber server into the publisher server. (Replacing hard disks requires that you reinstall all software on the server, so you effectively have a replacement server.) On the replacement publisher server, you configure a new Connection cluster. When you connect the subscriber server to the new Connection cluster, the subscriber server replicates its data to the replacement publisher server without loss of service to the system. When the replacement publisher server has Primary or Secondary status, it begins to handle calls again.
And found out one discussion related to my problem too here
IntroductionCUCM Routing RulesDial String implementation PolicyCUCM Routing LogicSIP URI Call Routing Analysis+++ Case Study: 1 ++++++ Case Study: 2 +++Conclusion
Over the last few months, I have had the privilege of working on SI...
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...