Reorder when dialing Attendant Console Pilot point
First attempt at installing Attendant Console. Everything works (calls can be made and all internal calls monitored, directory is good, etc.) other than I get reorder tone when dialing the Pilot Point for the AC Hunt Group. I've checked everything in the F&SG checklists -- CcmLineLinkState is 11, ac user password is 12345, TCD and CTIManager have been restarted, Pilot Point and all DNs on all AC user devices are associated with ac, Pilot Point is unique, etc. Any ideas?
Re: Reorder when dialing Attendant Console Pilot point
Have a look at the following;
Q. Why do I get a fast busy when I call the pilot point?
A. The pilot point and/or the controlled phones are not in the controlled device list of the 'ac' user. You must create a user with id 'ac' from the Cisco CallManager user administration page, and associate all pilot points and attendant phones with this user. Make sure that this user checks Enable CTI Application Use. The default password for this user should be 12345. If you want to change the password, see How do I change the password for the 'ac' user?
Q. Why do I still get a fast busy when I call the pilot point after I have associated the devices with the ac user?
A. It can be that the user(s) specified in the user/line pair(s) in the hunt-group associated with the pilot point is not online. Log in and go online from the Cisco CallManager Attendant Console GUI. If this does not work, you may be running into Cisco bug ID CSCdw86252 ( registered customers only) - 'User Device Association is Lost Sometimes in Device Association page'. Go to the Cisco CallManager Administration pages and re-associate the relevant devices that are no longer associated with the user.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...