Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

RightFax board driver

Hi all,

I'm now deploying a Fax server. We use RightFax ver9.3. I've installed the Feature Pack 2 and FP2 SR6. But when installing Fax board (Brooktrout SR140), I got the error message: "The required INF file (\driver\pnp\trxstream.inf) is missing. Please specify a valid INF file for installing the plug and play boston device driver". And in the Brooktrout Configuration Tool window --> Call Control Parameters, there was a message: "There are no TRxStream boards currently installed on your system".

Could anyone pls explain this for me and give me some instructions?

Thanks,

hoanghiep

2 REPLIES
New Member

Re: RightFax board driver

Refer to the rightfax installation guide present in the following url and check the steps you have done to install the server as any errors in the installation might cause this problem.

Installation guide is present in the url below:

http://www.cisco.com/en/US/docs/voice_ip_comm/fax_server/93/93ciscofaxboard.pdf

New Member

RightFax board driver

Hello hoanghiep,

I am facing the same issue, can you tell how did u make it working ?

I have RF 9.3 with FP2 SR6

Regards,

836
Views
0
Helpful
2
Replies
CreatePlease login to create content