This is done from Active Directory Users and Computers (for Exchange integrations), which you can do on your Unity server. Go to Properties for the selected Distribution List and select the Exchange General Tab. You want to configure Message Restriction settings. For example, we configure Message restriction for the All Subscribers - unityservername distribution list by selecting Accept Messages: Only From: either userids or groups that we want to authorize. Save the updates by replying OK.
Hi .. must have been some delay as the restrictions are now in place (although it would have been better to advise of the failure rather than stating 'sent' and then sending a delivery receipt failure message)
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...