services url does not work during failover, all other services works
i have configured load-balancing on CSM and also configured a virtual IP for all URLs (information, directory, services & authentication) on the CCM (UCM 7.1.3). The problem is that the services button do not work while all other URLs work when publisher is down. if i set the services URL to the subscriber IP it only works when the publisher is up. but if i shut the publisher and configure the services url manually, it doesnt work still. could someone assist.
Re: services url does not work during failover, all other servic
On the CSM i have allowed port 8080 since all CCM URLs seems to have that port. I mean the directory url, information & authentication urls works well, when i press the services button, the phone just shows requesting. some background info, i have pub & sub. i had configured DNS failover but noticed its taking ages to connect to the subscriber when i take down the publisher. After configuring the CSM, i shutdown the ports where publisher is connected and this is when i notice the services URL doesn't respond. Do i need to allow other ports on the CSM?
IntroductionCUCM Routing RulesDial String implementation PolicyCUCM Routing LogicSIP URI Call Routing Analysis+++ Case Study: 1 ++++++ Case Study: 2 +++Conclusion
Over the last few months, I have had the privilege of working on SI...
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...