Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Setting up a Directory Handler

I am trying to setup the Directory Handler in Unity 5. Using the default pre-built handler, when I dial in I get the greeting and press 4 to search by name. I put in the name and it finds a match, but it does not route the call to the phone, it goes straight to that subscriber's mailbox. What might the problem be?

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Setting up a Directory Handler

Steve,

Check the Subscriber Template, then Call Transfer, then under 'Transfer Incoming Calls to Subscriber's Phone'. Make sure the option that says 'Yes, Ring Subscriber's Extension' is selected.

Transfer options apply to indirect calls, such as the one via the Directory Handler, so the configuration of the Transfer settings on the subscriber or template may be the cause of what you are seeing.

Hope this helps.

Regards,

Michael.

2 REPLIES
Cisco Employee

Re: Setting up a Directory Handler

Steve,

Check the Subscriber Template, then Call Transfer, then under 'Transfer Incoming Calls to Subscriber's Phone'. Make sure the option that says 'Yes, Ring Subscriber's Extension' is selected.

Transfer options apply to indirect calls, such as the one via the Directory Handler, so the configuration of the Transfer settings on the subscriber or template may be the cause of what you are seeing.

Hope this helps.

Regards,

Michael.

Community Member

Re: Setting up a Directory Handler

Thanks, that fixed it!

sk

109
Views
0
Helpful
2
Replies
CreatePlease to create content