We got a CUCM ver 10.0.1.10000-24.
Our client has about 170 Ip Phones user on one remote site.
We have configured SRST ont that site, here you have router's configuration ( related to SRST):
voice service voip
ip address trusted list
ipv4 10.11.67.11
ipv4 10.32.1.31
ipv4 10.32.1.90
ipv4 10.16.5.0
ipv4 10.16.5.0 255.255.255.0
no ip address trusted authenticate
allow-connections h323 to h323
allow-connections h323 to sip
allow-connections sip to h323
allow-connections sip to sip
no supplementary-service sip moved-temporarily
no supplementary-service sip refer
fax protocol t38 version 0 ls-redundancy 0 hs-redundancy 0 fallback none
h323
sip
bind control source-interface GigabitEthernet0/2
bind media source-interface GigabitEthernet0/2
min-se 90 session-expires 90
header-passing
error-passthru
registrar server
early-offer forced
midcall-signaling passthru
!
!
voice register global
system message SRST Mode
max-dn 150
max-pool 58
!
voice register pool 1
id network 10.16.5.0 mask 255.255.255.0
no digit collect kpml
dtmf-relay rtp-nte cisco-rtp sip-notify
codec g711ulaw
no vad
!
During tests about 60 Ip Iphones got registration with proper Directory Numbers. But when we try to with internals call from any DN, we got:
a) Calling Ip Phone: rings ONE time and call falls on reorder tone.
b) Called Ip Phone: keeps ringing..
And when we call from PSTN to internal pilot, the calls fall too and internal Ip Phone keeps ringing.
IMPORTANT tip: Ip phone's network 10.16.5.0/24 is not directly connected to our SRST voice gateway, but we have full access between this network and the voice gateway..
- Do you know what is missing on our voice gateway configuration?
- Do you know how I can set up a specific group of Ip Phones to get this registration 50 over 170?
Best regards