Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SIP trunk on CME

Hi,

does CME supports more than one SIP trunk to different devices?

Also

Does SIP trunk on CME supports more than one call either audio only or video calls??

Regards,

Ahmed Kamal

13 REPLIES

Re: SIP trunk on CME

Hi Ahmed,

CME supports multiple SIP trunks, yes. In sip-ua, you can only define one sip server though. CME will only register with one trunk - this may limit you from using more than one provider.

If your provider does not require for you to register then you can support as many trunks as you want via dial peers:

dial-peer voice 1 voip

destination-pattern ipv4:1.1.1.1

session protocol sip

dial-peer voice 2 voip

destination-pattern ipv4:2.2.2.2

session protocol sip

hth,

nick

New Member

Re: SIP trunk on CME

Hi nick,

Thanks for your reply but does SIP trunk supports more than one audio or video call over it.?

Re: SIP trunk on CME

Yes, you can have as many as you can get with the CPU / memory, which will be many hundreds of calls.

hth,

nick

New Member

Re: SIP trunk on CME

Hi nick,

could you explain this statement in more details plz:

"In sip-ua, you can only define one sip server though. CME will only register with one trunk "??

Re: SIP trunk on CME

You can only register to one SIP provider.

New Member

Re: SIP trunk on CME

Sorry,

But you mean register my router as a SIP gateway to provider's SIP registrar server?

Correct me if i am wrong.

New Member

Re: SIP trunk on CME

Sorry,

But you mean register my router as a SIP gateway to provider's SIP registrar server?

Correct me if i am wrong.

Re: SIP trunk on CME

Most SIP providers require for your gateway to register one or more numbers.

Our gateways at this time are limited to registering to one registrar only.

If you have a SIP trunk that does not require you to register your number, then you can have multiple.

New Member

Re: SIP trunk on CME

Thanks nick :)

New Member

Re: SIP trunk on CME

Hi nick,

could you explain this statement in more details plz:

"In sip-ua, you can only define one sip server though. CME will only register with one trunk "??

New Member

Re: SIP trunk on CME

Can my ip phones sccp or it must be sip?

Re: SIP trunk on CME

For SIP trunks your phones can be either.

-nick

New Member

Re: SIP trunk on CME

Hi nick,

So i attached my conf.,is there any missing config i should do.

Tandberg endpoint can call me but i can't,i got fast busy with "unknown number"

status,

436
Views
0
Helpful
13
Replies