I have unity 4.2, vm-only at two sites. Am trying to set up smtp netwroking between them. When I fwd a msg to other site I'm getting a reciept saying msg could not be delivered due to routing problem.
How can I tell if message got to remote unity?
Also, I've tried testing smtp connectivity between unity's-after entering the telnet cmd I receive "220 with a bunch of astericks". Upon entering the ehlo cmd, i get back, "500 5.3.3 unrecognized command"
any troubleshooting direction would be greatly appreciated.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...