Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

SRST Inbound translate calls fails

Hi, I have a issue in the translation of incoming calls on SRST mode, the way I receive the call to analize in CCM is that I have to change the digits strings, but when the GW is in SRST mode the analysis is not the same, the issue is that I need to translate that call from a num-exp.

To explain the analysis is like this, in the normal operation I receive a DID from a R2 trunk, then I change the strings 99.. to 49.., and send them to CCM, in the CCM I receive in a CTI Port to put in a Hunt Pilot that is called 45.. (in the order of any DID), and the final destination is a 40.. DN number, but when the GW is in SRST mode I receive a 99.. DID and change to 49.. but there no more a CCM to make the analisys, in that step I have to change the 49.. string to 40.. because is the DN registered in fallback mode, I put a translation rule  in the call-manager-fallback, but did not work.

Config....

!

translation-rule 1
Rule 1 49.. 4019

!

dial-peer voice 100 voip
destination-pattern [2,4,5,6]...
no modem passthrough
session target ipv4:10.10.1.1
incoming called-number .
dtmf-relay h245-alphanumeric
codec g729br8
fax-relay ecm disable
fax rate disable
!

num-exp 99.. 49..
!
!
!
call-manager-fallback
secondary-dialtone 9
max-conferences 4 gain -6
transfer-system full-consult
log table retain-timer 100
timeouts interdigit 4
ip source-address 10.11.100.253 port 2000 strict-match
max-ephones 25
max-dn 25
system message primary Modo de supervivencia
system message secondary SRST operando
keepalive 20
default-destination 5000
translate calling 1
translation-profile incoming 1
call-forward pattern .T
call-forward busy 4000
call-forward noan 4000 timeout 15
time-zone 8
date-format dd-mm-yy
!

Any advice?? thanks in advance.

Cesar

Everyone's tags (5)
1 REPLY
New Member

Re: SRST Inbound translate calls fails

Hi

I have a similar issue (the nunber expansion is for when the gateway is in SRST mode):

num-exp 3... 81313...

!

dial-peer voice 13 pots
description ** Local calls **
preference 1
destination-pattern [2-8]..[2-9]......
progress_ind setup enable 3
progress_ind alert enable 8
progress_ind progress enable 8
progress_ind connect enable 8
port 0/0/0:23
forward-digits all
prefix 1

The poblem is that if the gatway receives 312 xxx xxx numer the number gets translated to 8131312 xxx xxx

The dn range is 3000-3599

Does anybodynow of another solution to get round this issue.

I'm using CME mode of SRST

telephony-service
srst mode auto-provision none
srst dn line-mode dual

.....

Thanks

1175
Views
0
Helpful
1
Replies
CreatePlease to create content