I'm having a funny issue at one of my sites. We had a cct hit from out telco and instead of going into SRST the phones apparently reset themselves. I have no idea why and was wondering if someone has seen this happen.
My SRST config is as follows:
max-conferences 8 gain -6
ip source-address 172.xx.xx.xx port 2000
system message primary SRST Fallback Active
It's configred to match on my CUCM.
The cct was about 4 minutes, I thought that as soon as the phones realized there was no CUCM they would simply go into SRST and then back when the link came back up. But what the users at the site described was that the phones reboot.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.