SRST vm-integration, pattern direct behaves differently
I am comfiguring vm-integration for Unity integration during SRST.
I have a problem with the "pattern direct" command (the one that applies when you press the messages button). Any "#" I define in the pattern appears to be translated to a "T" in the dialled number string and this is causing the call to fail. "#"'s in any of the other patterns appears to be preserved correctly ?
Re: SRST vm-integration, pattern direct behaves differently
Cisco SRST can send and receive voice-mail messages from Cisco Unity and other voice-mail systems during Cisco CallManager fallback. When the WAN is down, a voice-mail system with Basic Rate Interface (BRI) or Primary Rate Interface (PRI) access to the Cisco SRST system uses ISDN signaling. Systems with foreign exchange office (FXO) or foreign exchange station (FXS) access connect to a public switched telephone network (PSTN) and use in-band dual tone multifrequency (DTMF) signaling.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...