I am looking for a guide of some kind to walk me through setting up my vmware based callmanager. I have callmanager installed already, I am looking to know what to do next? I am pretty sure I need some of the following (Partition, CSS, ???)
There is no guide to tell you what to do or configure first, you'll need to start working with the system and little by little understand the dependencies between the configs and what needs to be configured first because you need it for some other config.
Looking at the menus a top/down and left/right approach is usually the way you need to go thru.
Partitions, CSS, ccms, ccm groups and all elements related to a device pool (time group, locations, regions, etc) are usually the very first things you need to configure before anything else.
It also depends a lot on what you want/need to configure.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...