Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

T1/E1 redundancy in Route List

Hi All:

Can some one please help me to resolve the issue?

I have 2 route groups in a route list for a Dial pattern, but for testing purpose when I shut down one controller , it DOES NOT go automatically to 2nd route group.

RL_Toronto

--à RG-Tor  ----T1 with 24 channel in NM-HDV

à RG-Ottawa -----T1 with 24 channel in NM-HDV

9.[2-9]XXXXXX --  RL_Toronto

I tested each route group individually, it is working perfectly, however when I give it as redundant and shut down  one of the controller ( eg: When RG_Tor –T1 down, it should go to RG_Ottawa T1) but it is not taking the redundant T1 for backup.

Any suggestion would be much appreciated

1 ACCEPTED SOLUTION

Accepted Solutions

Re: T1/E1 redundancy in Route List

Well, are these gateways MGCP or H.323? Sounds like they may be H.323. If

so, you have some options. There is a Call Manager service parameter you

could look into: "Stop Routing on User Busy" and "Stop routing on

unallocated number". They are set to true by default, you can set them to

false and force the CUCM to hunt through the route list.

You could also opt to leverage the following gateway configuration instead

of modifying the service parameters. I prefer the gateway config myself:

no dial-peer outbound status-check pots

HTH.

Regards,

Bill

Please remember to rate helpful posts.

HTH -Bill (b) http://ucguerrilla.com (t) @ucguerrilla

Please remember to rate helpful responses and identify

2 REPLIES

Re: T1/E1 redundancy in Route List

Well, are these gateways MGCP or H.323? Sounds like they may be H.323. If

so, you have some options. There is a Call Manager service parameter you

could look into: "Stop Routing on User Busy" and "Stop routing on

unallocated number". They are set to true by default, you can set them to

false and force the CUCM to hunt through the route list.

You could also opt to leverage the following gateway configuration instead

of modifying the service parameters. I prefer the gateway config myself:

no dial-peer outbound status-check pots

HTH.

Regards,

Bill

Please remember to rate helpful posts.

HTH -Bill (b) http://ucguerrilla.com (t) @ucguerrilla

Please remember to rate helpful responses and identify

New Member

Re: T1/E1 redundancy in Route List

Hats off William Bell

its (no dial-peer outbound status-check pots)  works for me.. You got your reword

Appreciated for your time and help

U

405
Views
0
Helpful
2
Replies
CreatePlease to create content