Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

T1 PRI Q.

Is there a way to control where L1 & L2 signaling should terminate on MGCP GW.

I mean terminate on GW or CCM.

Is there such a command like "isdn bind-l3 ccm-manager" for L1 & L2???

2 REPLIES
Cisco Employee

Re: T1 PRI Q.

isdn layer one and two terminates on the T1 controller of the gateway. There is no command to change this termination such as there is for the ISDN Q931 layer.

New Member

Re: T1 PRI Q.

But if i asked such a Q. how I should answer it?

133
Views
0
Helpful
2
Replies