07-19-2008 09:33 AM - edited 03-18-2019 09:19 PM
Is there a way to control where L1 & L2 signaling should terminate on MGCP GW.
I mean terminate on GW or CCM.
Is there such a command like "isdn bind-l3 ccm-manager" for L1 & L2???
07-19-2008 10:20 AM
isdn layer one and two terminates on the T1 controller of the gateway. There is no command to change this termination such as there is for the ISDN Q931 layer.
07-20-2008 03:26 AM
But if i asked such a Q. how I should answer it?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide