Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

T1/PRI

Hi,

I am having a Adtran 908e router with OS version R10.9.4.E
I want to replace it with Cisco 2911 so I am confused in migrating the configuration of T1/PRI from Adtran to Cisco.

My Adtran device config is :

interface t1 0/1
 tdm-group 1 timeslots 1-24 speed 64
interface t1 0/2
  shutdown
!
interface t1 0/3
  shutdown
!
interface t1 0/4
tdm-group 1 timeslots 1-24 speed 64

interface pri 1
  role network b-channel-restarts enable
  isdn name-delivery display
  connect t1 0/4 tdm-group 1
  isdn connect enable pi-2
  isdn setup enable pi-1
  no shutdown

interface ppp 1
  ip address  
  ip flow ingress
  ip flow egress
  media-gateway ip primary
  bandwidth 1544
  max-reserved-bandwidth 90
  no shutdown
  cross-connect 1 t1 0/1 1 ppp 1


voice feature-mode network
voice forward-mode network
!

 

voice trunk T01 type isdn

 

voice grouped-trunk

 

This is the configuration and I want to migrate this configuration on Cisco 2911.

If any buddy know this please help Me.

 

1 ACCEPTED SOLUTION

Accepted Solutions

your config would look

your config would look similar to this:

card type t1 0 0

network-clock-participate wic 0

isdn switch-type primary-ni 

controller t1 0/0/0

pri-group timeslots 1-24

no shut

interface serial 0/0/0:23

 no ip address
 encapsulation hdlc
 isdn incoming-voice voice
 no cdp enable

1 REPLY

your config would look

your config would look similar to this:

card type t1 0 0

network-clock-participate wic 0

isdn switch-type primary-ni 

controller t1 0/0/0

pri-group timeslots 1-24

no shut

interface serial 0/0/0:23

 no ip address
 encapsulation hdlc
 isdn incoming-voice voice
 no cdp enable

137
Views
5
Helpful
1
Replies
CreatePlease to create content