At present I have firmware rev 8.3.1 on my 7941s, so that does not appear to be the issue. From what I am reading, the IP-phones obtain time information from two locations: the CM for "timezone" offset and the SRST for UTC.
My CM Date/Time group shows "Eastern Std/Daylight GMT-5" which is correct. I have NTP enabled.
I will continue to search, but if you (or anyone) has additional tips, it will be much appreciated.
I am also having the same problem. I noticed on the 6.0 CM that the options for Easter Standard time, both with and without daylight savings both show GMT -5. Currently with daylight savings, Eastern timezone should be -4. The 6.0 CM is bugged!
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...