Can we extention the dialing time on a single phone. Example, dial 8, to activiate outside line, then dial the area code, then look away to find the rest of the number, by the time you find the rest of the number, the display has cleared, if you do not pick up the handset or if you have picked up the handset, it dials the 4 numbers and saids the call cannot be completed. Can we increase this time per user?
Tim Y is correct, you can not modify the inter-digit timeout on a per-phone basis.
If extending the inter-digit timeout is not a good enough option for you, you can try teaching your users to "en-bloc" dial. This consists of the user typing in the phone number they would like to dial, and then picking up the handset after they have dialed the number. This sends the whole "block" of digits to CUCM or CME in one block. The benefit to this method is it allows the user to spend more time entering digits.
Please mark helpful answers as correct and remember to rate posts.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.