Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

trace logs with PIMG

Unity 4.2 with PIMG on Nortel M1:

I want to troubleshoot some integration problems regarding the incoming display on the PIMG ports. Any specific logs helpful on this? Are there integration level logs on the PIMG?

thanks,

Scott

1 ACCEPTED SOLUTION

Accepted Solutions

Re: trace logs with PIMG

You can open up Hyperterminal on windows, telnet to the pimg and type in

Hyperterm via tcpip to the PIMG ip address

From the hyperterm menu, select Transfer > Capture Text

Enter the path\filename where to save it

Click start

hit enter a couple times in the hyperterm console

In the console, type "pwd", then Enter

In the console, type the password, then Enter

In the console, type "trace all off", then Enter

In the console, type "trace voip all on", then Enter

In the console, type "trace tel all on", then Enter

In the console, type "exit", then Enter **only hit Enter once, do not hit it again or it will end the trace**

Place your test calls

From the hyperterm menu, select Transfer > Stop

In the console, hit Enter to stop the trace

These will be raw logs from the PIMG.

What kind of problem are you having?

5 REPLIES

Re: trace logs with PIMG

You can open up Hyperterminal on windows, telnet to the pimg and type in

Hyperterm via tcpip to the PIMG ip address

From the hyperterm menu, select Transfer > Capture Text

Enter the path\filename where to save it

Click start

hit enter a couple times in the hyperterm console

In the console, type "pwd", then Enter

In the console, type the password, then Enter

In the console, type "trace all off", then Enter

In the console, type "trace voip all on", then Enter

In the console, type "trace tel all on", then Enter

In the console, type "exit", then Enter **only hit Enter once, do not hit it again or it will end the trace**

Place your test calls

From the hyperterm menu, select Transfer > Stop

In the console, hit Enter to stop the trace

These will be raw logs from the PIMG.

What kind of problem are you having?

Cisco Employee

Re: trace logs with PIMG

With newer PIMG firmware you can set and gather traces through the web admin. See the Diagnostics chapter of the User's Guide for more detail...

http://resource.dialogic.com/telecom/support/pimg/manuals/UsersGuide.pdf

-Eric

New Member

Re: trace logs with PIMG

Thanks, I tried both methods - works ok. "trace tel events on" is good for watching the incoming call display. This needed to be done due to some phones having more than 23 characters in the name field which results in failure of integration. As soon as you shorten the name they work

Scott

Re: trace logs with PIMG

Even if their characters are less than 23, I have had issues with PIMGs not pharses the name correctly. such as Robert Ward, would not work, but if changed it to R Ward on the PBX, then the PIMG would hand the call to Unity correctly. Go figure.

Glad you found your issue

cheers

Cisco Employee

Re: trace logs with PIMG

The issue with names ending in "T" is a known bug in some of PIMG's default parsing rules. See CSCsg01356 for more info.

162
Views
0
Helpful
5
Replies
CreatePlease to create content