Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Transcoding

Hi,

I configured transcoding using dsp resources on a 2800 series router and place the xcoder resource in a media resource group on callmanager7.

I then placed it into a MRGL for use.

With conference bridge resources I found out that I can use the resource from a non local router.

For example, I can place the mgrl that contains conference resources of the HQ router for use on the phone of a remote site.

However, I could not use remote xcoder resources to do transcoding on a local router.

Did I do something wrong or is this not suppose to work ?

Any help appreciated.

Thanks,

Paul

1 REPLY

Re: Transcoding

Hi paul,

yes you can use a conf bridge in a remote site but note that you will have the bandwidth of the 3-calls or more in your wan.

Also I think as you said transcoding could be used by the local ip phones only, remote phones couldn't use it

thanks

128
Views
0
Helpful
1
Replies