Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Transparent signaling configuration

Hello, I have a PBX that we want to connect to a Cisco GW through an E1 connection, this GW to another GW through Fastethernet and finally the second GW to a second PBX through another E1:

PBX_1--E1_1--GW_1--FE--GW_2--E1_2--PBX_2

I used this configuration on both GWs but it's not working, when I issue the command "show voice port summary", the trunk is down.

Do you see anything wrong at the configs?. Any help would be appreciated.

Thanks in advance.

Daniel Salamanca

2 REPLIES
Hall of Fame Super Gold

Re: Transparent signaling configuration

You are using to use transparent signaling, but that configuration is not enough. There would be many more commands needed.

Begin with regular PRI configuration and you will have better results.

Of course, you need to check "show controller E1 to be Ok before anything may work.

New Member

Re: Transparent signaling configuration

Hello,

When you say "regular PRI

configuration", what do you mean? Typically we only configure framing, and the command "pri-group" but it's not allowed here since I am using ds0-group.

The show controller E1 is showing some errors but not too many, maybe it is the cause of the problem

163
Views
0
Helpful
2
Replies