TSP update from 7.0(4) to 8.13) issues on 4.0(4) SR 1
Any one seen issues where calls do not answer after rebooting after TSP update from 7.0(4) to 8.1(3) ? We rebooted twice and second boot also did not get calls answered. The VM ports were all registered, etc. The error below is only thing in event log since boot up. We got it working by stopping unity from system tray icon and starting it from system tray but have not tried another reboot yet to see if all starts up fine and unit answers call fine on reboot on it's own.
Event Type: Error
Event Source: CiscoUnity_TSP
Event Category: None
Event ID: 158
Time: 8:14:37 AM
Cisco Unity-CM TSP device 7 (Cisco Unity port 4): Unexpected state transition requested. This Cisco Unity port may be in an undefined state. Requested state = <Idle>. Current state = <Wait For Answer Requested>.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...