UC320W Not connecting to ADSL Using Netgear DM111P
Hi all, I have a UC320W conencted to a netgear modem that died. I replaced it with a DM111P and the UC320W will not connect to the WAN. I have tested the line etc and the modem connects fine when direct connected to a PC. I have tried also a 2Wire Bigpond modem to no avail.
I am getting a solid ADSL light and the WAN connection does not come up.
I have checked the login details. They are correct. I have changed the WAN connection type, restarted the UC and then back to PPoE and again nothing.
Have now been waiting on hold to Cisco support for 45 minutes and desparate to get this one back up as phones are off air.
Help please. Is there an incompatibility issue with the UC320W and modems?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.