Voice messages can be correctly left in the voice mailbox, but MWI cannot reach phones. I have tried all three ways of delivering MWI with no success.
CME is SIP trunking to a SIP proxy server for PSTN calls. This part is working fine.
From CUE debugs, I can see the CUE is sending the MWI SIP messages to the CME; but no debug messages appear in CME (with 'debug ccsip all' and 'debug voice dialpeer all'). So the WMI does not reach CME.
interface Loopback0 ip address 10.1.10.2 255.255.255.252 ip virtual-reassembly ! interface Integrated-Service-Engine0/0 ip unnumbered Loopback0 ip virtual-reassembly service-module ip address 10.1.10.1 255.255.255.252 service-module ip default-gateway 10.1.10.2 ! dial-peer voice 2000 voip description ** cue voicemail pilot number ** answer-address 1099 destination-pattern 1099 b2bua session protocol sipv2 session target ipv4:10.1.10.1 incoming called-number 88.... dtmf-relay sip-notify codec g711ulaw no vad ! ephone-dn 159 number 888.... mwi off ! ! ephone-dn 160 number 889.... mwi on !
UC500-CUE# sh ccn su sip SIP Gateway: 10.1.10.2 SIP Port Number: 5060 DTMF Relay: sip-notify,sub-notify MWI Notification: outcall Transfer Mode: bye-also SIP RFC Compliance: Pre-RFC3261
UC500-CUE# sh ccn app
Name: ciscomwiapplication Description: ciscomwiapplication Application type: aa Script: setmwi.aef ID number: 0 Enabled: yes Maximum number of sessions: 6 CallControlGroupID: 0 strMWI_OFF_DN: 888 strMWI_ON_DN: 889
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...