Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

UC520 with two FXO lines for calls - number trans?

Hello I have a UC520 with only two pots lines for calls in a line hunt. There are no DID's, only the number for the pots line hunt group. I'am using a 4 digit dial plan. What do i have to configure to strip the last 4 digits and send it to unity express for the AA? I already have a dial-peer for the 4 digits pointing to unity express. Do I need to perform a number translation rule to truncate it down to 4 digits, or use a dial-plan? Thanks

3 REPLIES

Re: UC520 with two FXO lines for calls - number trans?

You can configure the following. This example uses 1234 for the AA DN.

voice-port 0/1/0

connection plar 1234

voice-port 0/1/1

connection plar 1234

Hope this helps.

Brandon

New Member

Re: UC520 with two FXO lines for calls - number trans?

Brandon,

so what will happen here is when the voice-port comes up to recieve a call it will automatically dial my AA extension? What about outgoing calls such a 911 or, this won't have an effect on them right? It's only incoming. I believe my outgoing dial-peers are all correct. Thanks

Jason

Re: UC520 with two FXO lines for calls - number trans?

Jason,

That is correct. No effect on outgoing calls.

Brandon

143
Views
0
Helpful
3
Replies