I have successfully done a lab setup on the UC540, CUE and phones are all working fine.
Ive just receive a UC560 from work for customer deployment. It has some slight differences/problem, which i am unable to rectify. I am unable to reach the CUE Module via ping or etc. It does not seem to be communicating with the CCME
Due to the network design, i am not using the UC all in box fw,uc,acl services.
Therefore, from CLI i have removed whatever preconfigured config in the UC.
I am treating the UC box as a pure CCME router as how the ISR router would.
That said below is my cut out config.
interface GigabitEthernet0/0 description Connection to idcsw01 GE0/22 ip address 10.10.20.10 255.255.255.0 duplex auto speed auto !
interface Integrated-Service-Engine0/0 description Loopback interface used to manage integrated application module ip unnumbered GigabitEthernet0/0 service-module ip address 10.10.20.11 255.255.255.0 service-module ip default-gateway 10.10.20.1 ! interface GigabitEthernet0/1/0 ! interface GigabitEthernet0/1/1 ! interface GigabitEthernet0/1/2 ! interface GigabitEthernet0/1/3 description Interface used to communicate with integrated service modue service-module ip address 10.10.20.11 255.255.255.0 service-module ip default-gateway 10.10.20.1 !
ip route 10.10.20.11 255.255.255.255 Integrated-Service-Engine0/0
The UC560 has a different port nature as the UC520.
Whatever configured on the interface Integrated-Service-Engine0/0 is mirrorred to interface GigabitEthernet0/1/3. UC520 does not have this, UC520 works fine with the identical config as above.
Due to this difference, the CUE is unreachable. Not pingable from the UC560.
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...