Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

UCCX 8.0 DB replication

Hi all,

We have UCCX 8.0 HA setup for a customer. All the services are Master on Subscriber and slave on Publisher. We are doing the MACD on Publisher and the changes are replicated on to subscriber. For ex, In publisher, under the default team , there is only on agent shown as assigned resources (Meaning other agents are assigned to newly created teams). But from the subscriber, under the Deafult team, there are lot of agent shown as Assigned resources.

We have recently done Su4 upgrade also. tried with Utils dbreplication repair all command and no luck with that.

Please help me resolve this issue.

Thanks

Bala.

Everyone's tags (4)
5 REPLIES

UCCX 8.0 DB replication

Hi Bala,

Please access the UCCX Serviceability page and navigate to Tools->Datastore control center->Replication servers and click on Reset Replication.

And also navigate to

Tools->Datastore control center->Datastores and for each of the datastores (Agent\config\Historical\Repository) perform synchronise data operation.

Hope it helps.

Anand

Please rate helpful posts by clicking on the stars below the right answer !!

UCCX 8.0 DB replication

Hi Anand,

Thanks for the response. Actually A TAC was created for this issue after this post . TAC engineer did the same thing but slighlty different.

He did "Disable CDS and HDS" and enabled it on the same page. Once after that everything started replicating from Pub to Sub.

Secondly when we were checking the status here, for the config data store, the Synchronise Data operation button was grayed out. This is just a finding.

Now everything works normal

Thanks once again anand for the reponse .

Thanks

Bala.

New Member

UCCX 8.0 DB replication

If there are common causes for why db replication stops happening could you share?

UCCX 8.0 DB replication

Mostly it is related to the network connectivity. The other reason what Cisco said was, if the servers are not brought down properly and that would result in db table sync process failure.

UCCX 8.0 DB replication

Hi Rajan,

In UCCXHA over WAN deployments one of the other common reason is ISLAND mode.

Refer Page 68:

http://www.cisco.com/en/US/docs/voice_ip_comm/cust_contact/contact_center/crs/express_8_5/design/uccx851srnd.pdf

And also,

https://communities.cisco.com/videos/4250

Hope it helps.

Anand

Pls rate helpful posts !!

4442
Views
3
Helpful
5
Replies