Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Uinified Personal Communicator & Firewall

We are trying to log-in using the Cisco Unified Personal Communicator from outside our firewall. We have opened all applicable ports and are using NAT for the presence server to allow login.

However, after the login succeeds the software can't find the TFTP or CM servers. I found the following line in some documentation and fear it means our set-up will never work.

"The Cisco Unified Personal Communicator is not compatible with Network Address Translation (NAT). Cisco Unified Personal Communicator cannot use Simple Traversal of UDP through Network Address Translation (STUN), Traversal using NAT (TURN), or any other NAT-traversal scheme.

To traverse NAT, Cisco Unified Personal Communicator must be behind a virtual private network (VPN) connection."

Can someone verify for me that I am reading this correctly? If not, what do I need to set to tell the Presence server or the client software to gain a full connection?

2 REPLIES
Red

Re: Uinified Personal Communicator & Firewall

NAT should be ok for TFTP. But it might cause problem on CUPC registration (SIP). Make sure your NAT is SIP aware and was able to do packet inspection.

Michael

http://htluo.blogspot.com/

New Member

Re: Uinified Personal Communicator & Firewall

Any luck with your issue? I'm trying to setup the same thing.

402
Views
0
Helpful
2
Replies